AMETEK ReFlex Programming Manual - Manual (Page 24)

ReFlex Power™ Programming Manual Controller Module Remote Programming
20 M380056-03 Rev M
2.3 POWER-ON CONDITIONS AND ADDRESS
CONFIGURATION
Table 2-1 presents remote power-on conditions for the ReFlex Power™
Controller (RFPC).
Table 2-1. Remote Power-On Conditions
Condition Default
Service Request Capability
Off, can be enabled by command and IVI Driver
configuration.
2.4 ETHERNET CONFIGURATION AND REMOTE
PROGRAMMING
Operating the ReFlex Power™ system via the Controller module requires
a computer with an Ethernet LAN connection. The Controller
communication interface conforms to IEEE 802.3, commonly known as
Ethernet 10 Base-T and 100 Base-T, and is
™ (LAN eXtensions for
Instrumentation) class C compliant.
After installing the IVI-COM drivers (Section 1.3.1), begin the Ethernet
connection and setup for communication.
2.4.1 E THERNET C ONNECTION R EQUIREMENTS
For Ethernet connection between the ReFlex Power™ Controller module
and the control computer, you will need:
• EnetTest.exe file located in the RFP Download folder on the ReFlex
Power™ CD-ROM (P/N M380399-01) supplied with your product
• LXI_Browser_setup.exe file (if you don’t know the IP address of the
Controller module), which is also located in the RFP Download folder
•
RJ45-type connectors with Category 5 or 5e (Cat 5) cables:
o For a network connection, via local router, switch or hub, to
isolate the local nodes and segments from the rest of the
network, use two straight-through cables.
o For a direct connection, if the control computer’s Ethernet
interface does not support Auto-MDIX, use a crossover cable
to connect the control computer directly to the Controller
module via their respective Net/LAN connectors.
•
Jumper plug to enable voltage output of each module as follows:
o For the ReFlex Power™ Controller module, you will need
either Loop-back Connector Assembly 5380509-01 or Cable
Assembly 5380441-01 or –03.