AMETEK ReFlex Programming Manual - Manual (Page 103)

AC Module Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 99
4.7 MEASURE SCPI COMMANDS
4.7.1 MEASURE SCPI C OMMAND S UMMARY
MEASure
:CURRent?
:VOLTage?
:FREQuency?
:PHASe?
:POWer
[:AC]
[:REAL]?
:APParent?
:VAR?
:PFACtor?
:CFACtor?
:IPEak?
4.7.2 MEASURE SCPI C OMMAND R EFERENCE
Command Description
MEASure MEASURE subset of SCPI command sets. Valid at Module level only.
:CURRent? Returns measured RMS output current.
:VOLTage? Returns the RMS output voltage.
:FREQuency? Returns the set measured frequency of the unit in Hz
:PHASe? Returns the setpoint value of the phase angle.
:POWer? Returns real power measurement
:APParent? Returns apparent power measurement (VA)
:VAR? Returns reactive power measurement
:PFACtor? Returns Power Factor measurement
:CFACtor? Returns current crest factor
:IPEak? Returns peak current reading