AMETEK ReFlex Programming Manual - Manual (Page 80)

ReFlex Power™ Programming Manual DC Module Remote Programming
76 M380056-03 Rev M
There may be additional commands added as the product is applied.
The non-LIST commands that interact with LISTs during creation are:
OUTP:ISOL:DEF
OUTP:SENSE:DEF
OUTP:STATE
OUTP:POL
SOUR:CURR <+NRf>
SOUR:CURR:PROT <+NRf>
SOUR:CURR:PROT:TRACK
SOUR:VOLT <+NRf>
SOUR:VOLT:PROT <+NRf>
SOUR:VOLT:PROT:TRACK
SOUR:UNDERVOLT:PROT <+NRf>
SOUR:UNDERVOLT:PROT:TRACK
TRIG:TRIG
TRIG:INP , OUTP
TRIG:OUTP , INP
TRIG:INP
TRIG:OUTP
TRIG:INPut:SLOPe [POSitive | NEGative | BOTH | NONE]
TRIG:OUTput:SLOPe [POSitive | NEGative | BOTH]
TRIG:WIDTh <+NRF>
See Section 3.15 for a summary and description of the LIST commands.
L IST T RIGGER G ROUPS
All ReFlex Power™ high power and low power DC power modules can be
programmed to respond to the common trigger buss. The response to the
trigger or triggers allows a complex cross module type tightly timed sequence
to result. All this on a single module basis there is little new, the novel part is
to establish a trigger sequence that crosses several modules.
One new concept is to assign one or more power modules one or more
trigger pulses from a pulse sequence. If the pulse sequence is very tightly
timed and well described, the result is a complex well-timed sequence of
events. The following figure and associated table describes this concept.
1 2 3 4 5 6
Figure 3-9. Group Pulse Sequence