Toa M-864D Ver.2.2.0 - Manual (Page 89)

89
[ext VoL. Gain]
Used to increase or reduce the EXT VOL. fader gain for the selected channels. Use the “Channel Kind” column
of Parameter 1 and the “Channel No.” column of Parameter 2 to select the channel. The gain increases or
decreases by 1 dB with each depression of the ZM Remote Controller’s button. If the button is held down and
the terminal is kept closed, the gain continues to increase or decrease.
Notes
• This function is allocated to 2 buttons in consecutive order.
Gain “Up” is allocated to the button with the lower number, and gain “Down” is allocated to the button with
the higher number. For example, if this function is selected for Button 2, it is automatically allocated to both
Buttons 2 and 3, giving Button 2 the “Up” function and Button 3 the “Down” function.
For this reason, it is impossible to allocate the “UP” function to Button 4 of the ZM-9011 and ZM-9014 Remote
Controllers and to Button 8 of the ZM-9013 Remote Controller.
• This function does not work even if allocated to any channel that has its EXT VOL. fader disabled.
[St Line Source Select]
Selects stereo input sources (A, B and C).
Select stereo input 1 or 2 in the “Channel No.” column of Parameter 1. For A, B and C channel selection, use
the “Line Source” column of Parameter 2.
Operation differs depending on the stereo input trim mode settings.
(1) MIx aLL mode
The ON and OFF settings of Terminals A, B and C set in the “Line Source” column are switched. Sources
are toggled between ON and OFF each time the ZM Remote Controller’s corresponding button is pressed.
(2) SeLeCt mode
Input source A, B or C set in the “Line Source” column is selected and set to ON when its corresponding
ZM Remote Controller’s button is pressed. When sources A, B and C are assigned to multiple buttons, the
last selected button takes precedence.
[Matrix Crosspoint assign]
The assign ON/OFF settings of the specified matrix crosspoint are switched. Select the crosspoint in the “Input
Channel” column of Parameter 1 and in the “Output Channel” column of Parameter 2.
Parameter 1 Parameter 2
Input channel Output channel
Mono In 1 – 8
Mono Out 1 – 4
Stereo In 1 – 2
Assignment status alternates between ON and OFF with each depression of the ZM Remote Controller’s
corresponding button.
[Matrix Crosspoint Gain]
Used to increase or reduce the specified matrix crosspoint’s gain. Select the crosspoint in the “Input Channel”
column of Parameter 1 and in the “Output Channel” column of Parameter 2.
The gain increases or decreases by 1 dB with each depression of the ZM Remote Controller’s button. If the
button is held down and the terminal is kept closed, the gain continues to increase or decrease.
Note
This function is allocated to any 2 buttons in consecutive order.
Gain “Up” is allocated to the button with the lower number, and gain “Down” is allocated to the button with the
higher number. For example, if this function is selected for Button 2, it is automatically allocated to both Buttons
2 and 3, giving Button 2 the “Up” function and Button 3 the “Down” function.
For this reason, the “UP” function cannot be assigned to Button 4 of the ZM-9011 and ZM-9014 Remote
Controllers, and to Button 8 of the ZM-9013 Remote Controller.