Toa M-864D Ver.2.2.0 - Manual (Page 78)

78
Step 5. Delete the unit from the list.
Select the unit to be deleted, then click the[Delete] button.
The selected unit is deleted from the list.
Step 6 Click the[Next] button, then the Firmware version check screen is displayed.
• When the firmware version of the M-864D is older than that the M-864D software supports, the
M-864D is displayed in the Uncontrollable units list.
• If a unit that does not need to be controlled is displayed, advance to Step 7 to delete it from the list.
• When updating firmware, advance to Step 8 .
• If all units to be controlled are shown in the Controllable units list, advance to Step 9.
Step 7. Delete the unit from the list.
Select the unit to be deleted, then click the [Delete] button.
The selected unit is deleted from the list.
Step 8. Update the firmware.
Select the unit from the Uncontrollable units list and click the [Firmware update] button.
Firmware update starts.
The unit is moved to and displayed in the Controllable units list after the firmware update is complete.
Notes
• Updating the firmware version from Ver. 1.0.x to Ver. 2.0.x causes the unit to reactivate twice. (“x”
represents a revision number.)
Never switch off the M-864D unit’s power during firmware update.
• The setting data is retained even after firmware update.
Step 9. Select the unit(s) from the Controllable units list.
Step 10. Click the[Finish] button.
Setting is complete.
7
8
10