Preset memory settings, P. 102 – Toa M-864D Ver.2.2.0 User Manual
Page 102
102
11.4. Preset Memory Settings
Select [Config Preset Memory Setting] in the Menu view to display the preset Memory settings screen.
(1) Preset Memory No.
(1) (2)
(3)
(2) Preset Memory name
(3) Cross-fade time settings
(4) Primary Reference Preset No.
selection button
(5) Preset Link setting
[Name and Cross-fade time Settings]
Set the name and cross-fade time for each Preset Memory.
[Primary reference Preset No. Setting]
1. Preset Memory No.
The Preset Memory Number is displayed.
2. Preset Memory Name
The name of each Preset Memory is displayed.
Click on the button to enter the Preset Memory
name.
3. Cross-fade time Settings
Displays cross-fade time for each Preset Memory.
The downward-pointing triangle button shortens
the cross-fade time, and the upward-pointing
triangle button lengthens the cross-fade time.
The triangle buttons located in the “ALL” section
can be used to change cross-fade times for all
Preset Memories simultaneously.
4. Primary reference Preset No. Selection Button
The Preset Memory number is displayed.
The button corresponding to the Preset Memory
number in effect when the power is switched ON is
displayed in orange.
Click on the button to set the Preset Memory
number.
When [Resume] button is clicked to select, the
M-864D is activated in the status* just before the
power was switched OFF.
When any button other than [Resume] button is
selected, the corresponding Preset Memory is
recalled when the power is switched ON.
* Preset Memory that had been recalled just before
the power was switched OFF is loaded when the
power is switched ON. If the Preset Memory was
being edited at power-off, the M-864D is activated
in the status that the Preset Memory is in edit.
[Preset Link Setting]
5. Preset Link Setting
Displays the IP address of the unit that functions
as the master unit interlocking Preset Memory with
other units.
Click on the IP address indication to enter the IP
address.
To interlock the Preset Memory with other units,
designate the IP address of the unit that functions
as the master interlock unit.
Notes
• When the Preset Memory is not interlocked with
other units, set the IP address to the initial value
(0,0,0,0).
• The units that can be interlocked are the M-864D
and the DP-SP3.
Settings to be stored in the Preset Memories are set parameters of all setting items in the “Signal processing
.