Toa M-864D Ver.2.2.0 - Manual (Page 117)

117
13.3. PC Software Screen
13.3.1. flow view
Displays the M-864D's signal processing flow, and is used to perform advanced settings of each individual
signal processing function.
13.3.2. operation view
Displays the signal processing flow vertically like the M-864D's front panel configuration, and is used to perform
advanced settings of each individual signal processing function.
13.3.3. floating (window) state
A state that a window is being displayed independently of the Main screen window.
13.3.4. Box
Refers to the box expressing each signal processing function in the Flow view and Operation view. The Box is
also termed as Function box.
13.3.5. Detail setting panel
A screen used to perform detailed parameter settings for the signal processing function box.
This screen is displayed in the pop-up sub-view.
13.3.6. Pop-up sub-view
A window that pops up on the screen and is used to perform detailed settings.
It displays the Detail Settings panel of the selected box.
13.4. Signal Processing function
13.4.1. Gain box
A box provided in the Monaural input circuit.
It has each parameter for the Phantom power, PAD, Low cut filter, and Gain.
13.4.2. LCf (Low cut filter)
A filter that attenuates the frequency range lower than a cut off frequency for the Monaural input. A combination
of the filter on the analog circuit section and HPF (high-pass filter) on the digital signal processing section
realizes the LCF internally.
13.4.3. trim box
A box provided in the Stereo input circuit. It has Stereo input source change function and performs input trim
control for each source.
The front panel-mounted input (ST2-F) of Stereo input 2 is excluded for the settings on this trim box.
13.4.4. fader box
Consists of the following 3 types of faders connected in series in each channel: FRONT fader (REC OUT VOL.
for the recording output), PC VOL. fader, and EXT. VOL. fader.
13.4.5. tone box
A signal processing box that filters 3 bands (BASS, MID, and TREBLE) for the input channel.