Toa M-864D Ver.2.2.0 - Manual (Page 22)

22
[Gain]
Statuses of the phantom power ON/OFF, PAD, low-cut filter and gain are displayed.
(1) Phantom power (3) Low-cut filter
(2) PAD (4) Gain
1. Phantom Power
Displayed in orange when the phantom power is
ON, and in black when the phantom power is OFF.
2. PaD
Displayed in orange when PAD is ON, and in black
when PAD is OFF.
3. Low-Cut filter
Displays a curve as shown in the figure above
when the low-cut filter is ON, or a straight line as
shown in the figure below when OFF.
4. Gain
Displays gain values.
The following display shows the phantom power is OFF, PAD is ON, low-cut filter is OFF and gain is 0 dB:
(1) Phantom power (3) Low-cur filter
(2) PAD (4) Gain
For gain settings, see p. 47 “Function Box.”
[Level meter]
Displays the monaural input level.
The post-processing gain level is displayed.
The level meter box is only displayed while in online mode.
[fader]
Displays individual gain values of the FRONT fader (fader on the unit’s front panel), PC VOL. (PC software
fader) and EXT VOL. (external control of the ZM Remote controller, etc.), as well as their total gain value.
When grouping has been set, the corresponding group number is displayed.
Each gain is also indicated by a bar extending from the left.
Faders set to “Disable” in the fader settings (see p. 99 ) are not displayed.
The FRONT fader gain is displayed only while in online mode.
When in offline mode, the total gain is obtained as 0 dB of the FRONT fader gain.
Note: Faders set to “Disable” are fixed at 0 dB gain.
For fader settings, see p. 49 , “Function Box.”
Group number