Toa M-864D Ver.2.2.0 User Manual
Page 83
83
• Function Settings
The following functions can be set for each terminal:
[Channel on/off]
Switches the selected channels On or Off.
Use the “Position” and “Channel/Contact” columns to select the channel.
The On/Off control method differs depending on the “Control” column settings.
Make: Channels are set to On when their terminals are shorted to the C terminal, and to Off when opened.
Pulse: Channels alternate between On and Off when their terminals are shorted to the C terminal.
[ext VoL. Up/Down]
Used to increase or reduce the EXT VOL. fader gain for the selected channels. Use the “Position” and “Channel/
Contact” columns to select the channels. Whenever a terminal is shorted to the C terminal, its gain increases
or decreases by 1 dB. If the button is held down and the terminal is kept closed, the gain continues to increase
or decrease.
Notes
• This function is allocated to any 2 terminals in consecutive order.
Gain “Up” is allocated to the terminal with the lower number, and gain “Down” is allocated to the terminal with
the higher number. For example, if this function is selected at Terminal 4, it is automatically allocated to both
Terminals 4 and 5, giving Terminal 4 the “Up” function and Terminal 5 the “Down” function.
The “Up” function cannot be assigned to Terminal 8. If this function is selected for Terminal 7, Terminal 7 will
be designated as “Up” and Terminal 8 as “Down.”
• This gain UP/DOWN function cannot be allocated to any channel that has its EXT VOL. fader disabled.
For EXT VOL. fader Enable/Disable settings, see
settings.
[St Line Source Select]
Used to select the stereo input source (connected to Terminals A, B and C of each stereo input).
Stereo Input 1 and Stereo Input 2 are selected in the “Channel/Contact” column. Use the “Parameter” column
to select Source A, B or C.
Operation differs depending on the stereo input trim mode settings.
MIX ALL mode: The ON/OFF settings of Terminals A, B and C set in the “Parameter” column are switched.
Sources are toggled between ON and OFF each time a connected terminal is shorted to the
C terminal.
SELECT mode: The input source set in the “Parameter” column is selected and set to ON when its
corresponding terminal is shorted to the C terminal.
When Sources A, B and C are assigned to multiple terminals, the last shorted terminal takes
precedence.
[Preset Memory Load]
Accesses the Preset Memory.
Set the Preset Memory (1 – 16) to be called up in the “Parameter” column.
The Preset Memory set in the “Parameter” column is accessed when its corresponding terminal is shorted to
the C terminal.
If different Preset Memories are assigned to multiple terminals, the last shorted terminal takes precedence.
[remote Command]
Assign the command number for the External control command send function to the terminals.
Shorting the corresponding terminal to the C terminal sends the specified command.
When no function is to be assigned to a terminal, select “None” in the “Function” column.