Toa M-864D Ver.2.2.0 - Manual (Page 85)

85
• Function Settings
The following functions can be set for each terminal:
[Break]
The terminal remains open.
[Make]
The terminal remains closed (shorted to the C terminal).
[Channel on/off]
Provides a Make or Break contact for the specified channel On/Off.
Select the channel in the “Position” and “Channel/Contact” columns.
The terminal is closed (Make contact) when the channel is On, and open (Break contact) when the channel is
Off.
[St Line Source Select]
Outputs a Make or Break contact depending on the selection status of the specified channel’s stereo input
source.
Set the selection status to be output in the “Parameter” column.
Select the channel in the “Channel/Contact” column.
Operation differs depending on the stereo input trim mode settings.
(1) MIx aLL mode
Provides a Make or Break contact according to ON/OFF status of Terminals A, B or C set in the “Parameter”
column.
The terminal is closed when ON and is opened when OFF.
(2) SeLeCt mode
Outputs a Make or Break contact depending on the selection status of A, B or C set in the “Parameter”
Column. The terminal is closed when selected and remains open when not selected.
[Preset Memory Load]
Outputs a Make or Break contact depending on the selection status of the specified Preset Memory.
Set the desired Preset Memory number in the “Parameter” column.
The terminal is closed if the Preset Memory set in the “Parameter” column is selected, and opened if another
Preset Memory is selected.
[Contact through out]
Outputs a Make or Break contact depending on the selection status of the specified Preset Memory.
Set the desired contact input terminal in the “Parameters” column.
If the contact input terminal set in the “Parameters” column is closed, the contact output terminal is also closed.
If the contact input terminal is opened, then the contact output terminal is also opened.