7 frequency setting via remote control signals, 7 frequency setting via remote control signals -9, Icnod – Toshiba VF-SX User Manual
Page 96: F n 0 d, Pfl 0 d]), Toshiba
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
10-9
10.7 Frequency Setting via Remote Control Signals
This portion of the manual describes how to run the drive at various user
assigned frequencies, which are determined by the use of external control
signals. The touchpad is not used for this operation, other than the initial
assignment of values and programming instructions.
After this programming is completed the drive may be run automatically. It may
be desirable, from a security standpoint, to disable the touchpad when
programming is completed, so that custom parameters and programming cannot be
changed or revised. See this chapter for details. (Parameters
icnod],
[F n 0 d],
and
[Pfl 0 d]).
The output frequency fs controlled externally using terminals PP, RR, IV, and CC
on the control circuit terminal blocks shown in Figure 10.4.