Toshiba VF-SX - Manual (Page 57)

8-12 TOSHIBA
8.3 PANEL/REMOTE Control
Either the "PANEL" mode or the "REMOTE" mode of drive control may be selected.
In the "REMOTE" mode any commands from the touchpad are ignored (except EMERGENCY
STOP). A brief explanation of the Emergency Stop function is shown in Section
8.4 in this chapter. See Chapter 11.3 for a complete explanation of the
EMERGENCY STOP function.
In the "PANEL" mode all commands from control signals connected to the terminal
blocks are ignored, including speed pots and 4-20mA input signals.
I PANEU I
Switching between the "PANEL" and "REMOTE" modes is accomplished with thel^SI!]
key on the touchpad. This setting can only be changed while the drive is
stopped. The LED display shows 0.0 when the drive is stopped.
The Comand Mode can be set so that "PANEL" control or "REMOTE" control is never
possible. See Chapter 10, parameter [ c n o d ], for an explanation.
When power is first turned ON the drive is energized in the drive mode. If the
drive is controlled from the touchpad the LED indicating "PANEL CONTROL" will be
illuminated. If the drive is not controlled by the touchpad this LED will not
be on, and the drive will accept input control signals from the terminal blocks.
8.4 Selection of Stopping Method from the Touchpad
The following three methods can be selected for stopping the drive from the
touchpad. All three methods use the e H i I key to implement a stop command to the
motor from the drive, as described below.
METHOD 1 — Ramp Stop When the Drive is in Panel Control
Step 1. Press the EIIIS key on the touchpad.
The drive will DECELERATE at the programmed rate to a complete stop.