Toshiba VF-SX - Manual (Page 60)

TOSHIBA 8-15
TABLE 8-5: STARTING THE DRIVE FROM THE TOUCHPAD
Procedure Operation
Power On Turn on power to the Inverter with the HCCB. If the
display shows [ O F F ] , the proper operating conditions
are not set, and operation will not be possible. Close
the connection between terminals ST and CC. Operation is
possible if r O . O l is displayed.
IPANEU 1
| pq ^ e [
IPANEU 1
Change to Panel Control by pushing the key. The
"PANEL CONTROL" LED will turn on. Operation from the
IMNEU 1
touchpad will now be possible. If the lf55Z!l button is
pushed again, the light will turn off, and touchpad
control will be deactivated.
| ei ^ er [
Adjustment of the operating frequency/speed is
accomplished from the and keys on the touchpad.
When these keys are depressed the "PANEL CONTROL" light
will flicker, indicating the numerical value in the LEO
display is changing. When the desired frequency is shown
press the key and the display will alternately show
F C and the frequency, in order. When the key is
depressed the assigned running frequency is stored in the
drive’s memory.
pp U N j
Depressing this key will energize the output circuits.
The frequency display will begin to increase at the
programmed acceleration rate, and the motor will begin to
rotate.
I^E °E t |
Depressing the I m M i I key will cause the inverter to ramp
the load to a stop at the programmed deceleration rate.
CAUTION:
If the power switch Is turned OFF during step 4 above, the motor will coast
to stop. However, DO HOT stop the Inverter In this fashion unless there is
an emergency. Always avoid starting and stopping the Inverter from the
power switch. ________________ ____________________