Toshiba VF-SX - Manual (Page 56)

TOSHIBA 8
-n
8.2.4 Jogging Mode from the Touchpad
This mode is used to operate the inverter at a low speed for brief intervals.
Short time operation ("inching") can be performed easily. The following
operations make use of the touchpad. U is also possible to use remote control
signals for the [ J O C ] feature. See Chapter 10 for instructions.
NOTE: Remember to set the Jog Run Frequency [ J O C ] and Jog Stop
Pattern [ l / 5 t P]before using the Jog feature. See the Chapter 10 for
instructions.
After these parameters are set, enter the Jogging Mode with touchpad control by
performing the following programming steps. Be sure the "PANEL CONTROL" LED is
ON.
TABLE 8-4: KEYSTROKES TO ENTER JOG FUNCTION FROM THE TOUCHPAD
Keys Display Explanation
EEH
S
: O r . U
: F J 0 0
Press the key TWICE. The Jogging mode is not
activated by any other keys. When using the touchpad
for jogging, and the jog frequency is set to some
value other than 0 HZ, the jogging mode is activated
by the second
EZZl
keystroke. When nai using the
touchpad or when the jogging run frequency is not
set, the second keystroke of the
EEEl
will return
the drive to drive mode (frequency display).
-.rJOG
Press the key to "jog run" reverse.
Press the key to "jog run" forward.
1 R U n |
5.0
The jog setting frequency will be output to the motor
while the key is depressed.
Q
0.0
The return to the Drive Mode press the key.