Toshiba VF-SX - Manual (Page 89)

10-2 TOSHIBA
This sectioa of the manual describes the functions which the control terminals
can perform. These terminals are used to send output signals about the condition
in which the drive is operating, and to accept remote signals for automatic
operation. The methods of disabling and enabling many different features of the
inverter are also described. The methods for assigning and programming the
control terminals are discussed, and examples are given of uses for the control
terminals. The terminals, functions and parameters discussed in this chapter are
shown below.
[ C n o d ]
Command Mode Selection
i F n O d ] Frequency Setting Mode Selection
[ P n o d ]
Parameter Setting Disable Selection
[ / fc b]
Input Terminal Selection
[Ofcb
] Output Terminal Selection
I L F] Low-speed Signal Output Frequency
[ L F H L ] Low-speed Signal Logic Selection
[ F r C H ] speed Reached Specifying Frequency
[ r C H ] Speed Reached Selection
1 .
2 .
3.
i.
5.
6 .
7.
8
.
9. _
10.
[ i - r C H ]
Speed Reached Detection Range
11. Frequency Setting via Remote Signals:
11a. [ / U / r>] Terminal IV Ii^ut
lib.
[ P I , F ^ P I , P d , F'~Pd]
Setting Signals
and Frequencies
11c. [(~(~
C C
] RR Terminal Input Prioritization
12. Jogging via Remote Signals
12a.
[d D C]
Jogging Run Frequency
12b.
[d 5 t P]
Jogging Stop Pattern
13. [ 5r O] Multi^eed Run
14. [ 5/* / — 5^7] Multiple Speed Operation Frequencies
10.1 Command Mode Selection [ C f l O d ]
The panel control mode (touchpad) and remote control mode are the two options
available to control the drive.
* When using the remote control mode the commands from the touchpad are ignored,
* When using the touchpad control mode all remote commands at terminal blocks are
ignored.