Toshiba VF-SX - Manual (Page 51)

8-6 TOSHIBA
These alarm displays will turn off automatically when the alarm conditions no
longer exist. Typically, the drive will eventually trip OFF if any one of these
conditions persists. See section 8.8 in this chapter for more details.
3. Trip Information
If the VF-SX drive trips while in the Drive Mode, the cause or type of this trip
will be displayed immediately on the LED monitor display. The display will
continuously flash a trip code indicating the cause of the trip. Furthermore,
the registered trip status can be read out from drive memory.
The flashing trip display will remain on continuously until the power is turned
"OFF" or the trip is cleared. Refer to Section 8.7 — Error Reset, (in this
chapter) for instructions to clear a trip, return to the Drive Mode, and run the
drive.
Table 8-1 below shows a list of all trip codes which the drive can display. This
information is also available in the Appendix.
Table 8-2 below shows an example of a drive trip occurrence, and of the data
stored for examination in drive memory when a trip occurs. Six other parameters
describing the software versions and past'trip history can also be observed by
stepping further into the menu shown in this Table. Press the or keys
to scroll through this data. If the I“”"! key is pressed next the initial trip
code will be shown.
If the or keys are pressed continuously during this procedure, the
displayed item will change every 0.5 seconds and display in order. The display
can be changed to the trip information display status by pressing the key
at any time during this procedure.