Toshiba – Toshiba VF-SX User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6-6
TOSHIBA
Example 5: To set the VF-SX Inverter for operation when a braking resistor is
connected. (This resistor is an optional device.)
Figure 6.5
Setting: Set the
Regenerative Discharge Braking Selection
to 2. (Enable the
braking resistor overload detection.)
In Figure 6.5 above:
1. Incoming power is 200-230 volts, three phase, 50 or 60 Hz.