F“^p i, F“p p, Toshiba 10-13 – Toshiba VF-SX User Manual
Page 100: Frequency setting signal
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
10-13
See Chapter 13, Part 2, and Figure 13.4 for an explanation of how changing the
gain and bias parameters affects the setting of the frequency setting signals.
2.
IV Terminal Frequency Setting Signal Characteristics
The characteristics of the frequency setting signals and output frequencies input
to the IV terminal can be set by setting parameter [
l u l r i ]
to / (enabled).
The characteristics are set with two points.
*
The point setting signal
[ P I ]
can be set between 0% and 100%.
*
The point 1 output frequency
[F“^P I
]
can be set between 0 and
the
maximum frequency.
*
The point
2
setting
signal
[P
P ]
can be set between
0%
and
100%.
*
The point 2 output
frequency
[F“P P]
can be set between 0 and
the
maximum frequency.
Hz
Frequency Setting Signal
Figure 10.6 Frequency Setting Signal
Characteristics of the IV Terminal