Toshiba VF-SX - Manual (Page 30)

TOSHIBA 6-3
Example 2: To set the operation frequencies from the touchpad, and conduct
forward/reverse run, decelerating stop, and/or coast!ng-to-stop with external
signals.
5X DRIVE
Figure 6.2
Setting; In the parameter group
[0
l~.
5 t
] the Command Mode Selection is set
to 3 (control terminal or touchpad input). Also, in the same parameter group
the Frequency Setting Mode Selection is set to 2 (only touchpad input valid).
In Figure 6.2 above:
1.
2
.
3.
4
.
Incoming power is 200-230 volts, three phase, 50 or 60 Hz.
When the ST-CC contact is open the drive will "Coast-to-Stop".
When the ST-CC contact is closed, and the F-CC contact is closed the
drive will run "Forward". If the F-CC contact is opened the drive
will decelerate stop.
When the ST-CC contact is closed, and the R-CC contact is closed the
drive will run "Reverse". If the R-CC contact is opened the drive
will decelerate stop.