Dell PowerVault DP600 - Manual (Page 57)

Using the System Setup Program
57
Assigning a System Password
Before you assign a system password, enter the System Setup program and
check the System Password option.
When a system password is assigned, the setting shown for the System
Password option is Enabled. If the setting shown for the Password Status is
Unlocked, you can change the system password. If the Password Status
option is Locked, you cannot change the system password. When the system
password feature is disabled by a jumper setting, the system password is
Disabled, and you cannot change or enter a new system password.
When a system password is not assigned and the password jumper on the
system board is in the enabled (default) position, the setting shown for the
System Password option is Not Enabled and the Password Status field is
Unlocked. To assign a system password:
1 Verify that the Password Status option is set to Unlocked.
2 Highlight the System Password option and press .
3 Type your new system password.
You can use up to 32 characters in your password.
As you press each character key (or the spacebar for a blank space), a
placeholder appears in the field.
The password assignment is not case-sensitive. However, certain key
combinations are not valid. If you enter one of these combinations, an
error message appears. To erase a character when entering your password,
press or the left-arrow key.
NOTE:
To escape from the field without assigning a system password, press
to move to another field, or press at any time prior to
completing step 5.
4 Press .
5 To confirm your password, type it a second time and press .
The setting shown for the System Password changes to Enabled. Exit the
System Setup program and begin using your system.
6 Either reboot your system now for your password protection to take effect
or continue working.
NOTE:
Password protection does not take effect until you reboot the system.
book.book Page 57 Monday, September 14, 2009 1:53 PM