Dell PowerVault DP600 - Manual (Page 89)

Installing System Components
89
Figure 3-15. Installing and Removing Expansion Cards
4 Remove the filler bracket on the slot you will be using.
NOTE:
Keep this bracket if you need to remove the expansion card. Filler
brackets must be installed over empty expansion-card slots to maintain Federal
Communications Commission (FCC) certification of the system. The brackets
also keep dust and dirt out of the system and aid in proper cooling and airflow
inside the system.
5 Align the expansion card with the card-edge guides and insert the expansion
card firmly into the expansion-card connector until the card is fully seated.
NOTE:
Ensure that the expansion-card bracket is also inserted into the
securing slot on the back of the expansion-card cage.
1 card-edge guide 2 expansion card 3 expansion-card retainer
3 2
1
book.book Page 89 Monday, September 14, 2009 1:53 PM