System board (service-only procedure), Removing the system board – Dell PowerVault DP600 User Manual
Page 136
136
Installing System Components
3 Install the control panel board in the system chassis and secure with the
three Phillips screws. See Figure 3-32.
4 Connect the display module ribbon cable to the control panel board.
See Figure 3-32.
5 Connect the control panel interface cable to the control panel board.
See Figure 3-32.
6 Close the system. See "Closing the System" on page 68.
7 If applicable, reinstall the top panel on your tower system:
a
Place the top panel on top of the system and offset slightly so that the
panel can engage the chassis hooks.
b
Slide the panel forward to closed position.
c
Install the retaining screw to the top back of the system.
8 Reconnect the system to the power source and turn on the system and
attached peripherals.
9 Replace the front bezel, if removed.
System Board (Service-Only Procedure)
Removing the System Board
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
CAUTION:
Whenever you need to lift the system, get others to assist you. To avoid
injury, do not attempt to lift the system by yourself.
1 Remove the front bezel, if attached. See "Removing the Bezel" on
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Detach all cables from the front and rear of the system.
4 If the system is a tower system, place it on its side on top of a work surface.
book.book Page 136 Monday, September 14, 2009 1:53 PM