Installing an optical drive – Dell PowerVault DP600 User Manual
Page 95
Installing System Components
95
4 Disconnect the cables from the SAS controller daughter card on the
expansion-bay bracket and pull the cables out of the way of the center
fans.
5 Remove the fans from the center fan bracket. See "Removing and
6 Remove the center fan bracket. See "Removing the Center Fan Bracket"
7 Push the spring latch at the top of the peripheral bay to the right and
partially extend the optical drive out of the bay. See Figure 3-16.
8 Remove the ribbon cable and the power cable from the back of the
optical drive.
9 Remove the optical drive from the bay.
10 Replace the optical drive or insert the filler plate over the empty drive slot.
11 Replace the center fan bracket. See "Replacing the Center Fan Bracket"
12 Replace the fans into the center fan bracket.
13 Reconnect the cables to the SAS controller daughter card.
14 Close the system. See "Closing the System" on page 68.
15 Replace the front bezel, if removed in step 2.
16 Reconnect the system and peripherals to their electrical outlets.
Installing an Optical Drive
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Remove the front bezel, if attached. See "Removing the Bezel" on
3 Open the system. See "Opening the System" on page 67.
book.book Page 95 Monday, September 14, 2009 1:53 PM