Dell PowerVault DP600 - Manual (Page 39)

About Your System
39
General failure The operating system is
unable to carry out the
command. This message is usually
followed by specific
information. Note the
information and take the
appropriate action to
resolve the problem.
Invalid NVRAM
configuration,
Resource Re-
allocated
System detected and
corrected a resource
conflict. No action is required.
Keyboard Controller
failure
Faulty keyboard
controller; faulty system
board See "Getting Help" on
page 185.
Manufacturing mode
detected
System is in
manufacturing mode. Reboot to take the system
out of manufacturing
mode.
MEMBIST failure -
The following
DIMM/rank has been
disabled by BIOS:
DIMM x Rank y
Faulty memory
module(s). See "Troubleshooting
System Memory" on
page 158.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
book.book Page 39 Monday, September 14, 2009 1:53 PM