Dell PowerVault DP600 - Manual (Page 114)

114
Installing System Components
NOTICE:
Be careful when disconnecting cables from the system board that you do
not damage the surrounding system board components. Be particularly careful that
you do not push or bend the system capacitors near the connectors.
6 Disconnect the management cable from the system board.
7 Disconnect the management cable from the RAC card.
8 Disconnect the MII cable from the system board.
9 Disconnect the MII cable from the RAC card.
10 Press down on the two blue RAC retention clips.
11 Rotate the RAC card away from the retention clips, and then slide the
RAC card out toward the front of the chassis.
Installing a RAC Card
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 67.
3 Remove the cooling shroud by pulling the release latches outward from
their securing tabs and lifting the shroud out of the system. See
Figure 3-20.
4 Remove the filler plug from the system back panel. See Figure 3-23.
book.book Page 114 Monday, September 14, 2009 1:53 PM