Dell PowerVault DP600 - Manual (Page 123)

Installing System Components
123
9 Replace the front bezel, if removed.
10 Reconnect the system to the electrical outlet and turn on the system and
attached peripherals.
Optional 1x2 Flex Bay Drive Bracket
Removing the 1x2 Flex Bay Drive Bracket
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Remove the front bezel, if attached. See "Removing the Bezel" on
page 64.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
3 Open the system. See "Opening the System" on page 67.
4 Push the latch on top of the peripheral bay to the right to release the flex
bay bracket and push the back of the flex bay bracket partially out of the
chassis. See Figure 3-26.
5 Note the order of SAS cable connections on the flex bay backplane and
disconnect the SAS cables. See Figure 3-26.
6 Disconnect the power cable from the flex bay backplane. See
Figure 3-26.
7 Remove the 1x2 flex bay drive bracket from the chassis bay.
book.book Page 123 Monday, September 14, 2009 1:53 PM