Installing a drive blank, Removing a hot-plug hard drive, Installing a hot-plug hard drive – Dell PowerVault DP600 User Manual
Page 72
72
Installing System Components
Installing a Drive Blank
The drive blank is keyed to ensure correct insertion into the drive bay. To
install a drive blank, insert the blank into the drive bay and press evenly on
the ends of the blank until it is fully inserted and latched.
Removing a Hot-Plug Hard Drive
1 Remove the front bezel, if attached. See "Removing the Bezel" on
2 From the RAID management software, prepare the drive for removal and
wait until the hard-drive indicators on the drive carrier signal that the
drive can be removed safely. See your SAS RAID controller
documentation for information about hot-plug drive removal.
If the drive has been online, the green activity/fault indicator will flash as
the drive is powered down. When both drive indicators are off, the drive
is ready for removal.
3 Open the drive carrier release handle to release the drive. See Figure 3-6.
4 Slide the hard drive out until it is free of the drive bay.
5 If you do not replace the hard drive, insert a drive blank in the vacated
drive bay. See "Installing a Drive Blank" on page 72.
NOTICE:
To maintain proper system cooling, all empty hard-drive bays must have
drive blanks installed.
Installing a Hot-Plug Hard Drive
1 Remove the front bezel, if attached. See "Removing the Bezel" on
2 If a drive blank is present in the bay, remove it. See "Removing a Drive
book.book Page 72 Monday, September 14, 2009 1:53 PM