Dell PowerVault DP600 - Manual (Page 30)

30
About Your System
E1A18 PDB Ctrl
Cable
The power distribution
board control cable is
unseated, missing, or bad. Ensure that the power
distribution board control
cable is seated properly. If
the problem persists,
replace the power
distribution board control
cable. See "Installing the
Power Distribution
Board" on page 142.
E2010 No Memory No memory is installed in
the system. Install memory. See
"Memory" on page 107.
E2011 Mem Config
Err
Memory detected, but is not
configurable. Error detected
during memory
configuration. See "Troubleshooting
System Memory" on
page 158.
E2012 Unusable
Memory
Memory is configured, but
not usable. Memory
subsystem failure. See "Troubleshooting
System Memory" on
page 158.
E2013 Shadow BIOS
Fail
The system BIOS failed to
copy its flash image into
memory. See "Troubleshooting
System Memory" on
page 158.
E2014 CMOS Fail CMOS failure. CMOS RAM
not functioning properly. See "Getting Help" on
page 185.
E2015 DMA
Controller
DMA controller failure. See "Getting Help" on
page 185.
E2016 Int
Controller
Interrupt controller failure. See "Getting Help" on
page 185.
E2017 Timer Fail Timer refresh failure. See "Getting Help" on
page 185.
E2018 Prog Timer Programmable interval timer
error See "Getting Help" on
page 185.
E2019 Parity Error Parity error. See "Getting Help" on
page 185.
Table 1-6. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 30 Monday, September 14, 2009 1:53 PM