Dell PowerVault DP600 - Manual (Page 36)

36
About Your System
DIMM pairs must be
matched in size,
speed, and
technology. The
following DIMM pair
is mismatched:
DIMM x and DIMM y.
Mismatched or
unmatched DIMMs
installed; faulty or
improperly seated
memory module(s). Ensure that all pairs of
memory modules are of the
same type and size and that
they are properly installed.
See "Memory" on page 107.
If the problem persists, see
"Troubleshooting System
Memory" on page 158.
DIMMs must be
populated in
sequential order
beginning with slot
1. The following
DIMM is electrically
isolated: DIMM x.
The specified DIMM is
inaccessible to the system
due to its location.
DIMMs must be
populated in sequential
order, beginning with
slot 1. Populate 2, 4, 8, or 12
DIMMs sequentially
beginning with slot 1. See
"Memory" on page 107.
DIMMs should be
installed in pairs.
Pairs must be
matched in size,
speed, and
technology.
Mismatched or
unmatched DIMMs
installed; faulty or
improperly seated
memory module(s). The
system will operate in a
degraded mode with
reduced ECC protection.
Only memory installed in
channel 0 will be
accessible. Ensure that all pairs of
memory modules are of the
same type and size and that
they are properly installed.
See "Memory" on page 107.
If the problem persists, see
"Troubleshooting System
Memory" on page 158.
Dual-rank DIMM
paired with Single-
rank DIMM - The
following DIMM/rank
has been disabled by
BIOS: DIMM x Rank y
Mismatched DIMMs
installed; faulty memory
module(s). The system
has detected a dual-rank
DIMM paired with a
single-rank DIMM. The
second rank of the dual-
rank DIMM will be
disabled. Ensure that all pairs of
memory modules are of the
same type and size and that
they are properly installed.
See "Memory" on page 107.
If the problem persists, see
"Troubleshooting System
Memory" on page 158.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
book.book Page 36 Monday, September 14, 2009 1:53 PM