Optical drive, Removing an optical drive – Dell PowerVault DP600 User Manual
Page 94
94
Installing System Components
8 Insert the new tape drive three-quarters of the way into the drive slot on
the peripheral bay, with the mounting screws entering the bay slide slots.
9 Connect the SCSI interface cable in the drive kit to the drive. See
Figure 3-16.
10 Connect the SCSI interface cable to the SCSI connector on the optional
SCSI controller card.
11 Connect the power cable to the power connector on the drive. If not
already done, connect the other end of the power cable to the CD/TBU
power connector on the SAS backplane. See Figure 6-3.
12 Push the tape drive the rest of the way into the bay until the spring latch
engages.
13 Close the system. See "Closing the System" on page 68.
14 Replace the front bezel, if it was removed in step 1.
15 Reconnect the system and peripherals to their electrical outlets, and turn
them on.
16 Finish configuring the SCSI tape backup unit according to the
documentation you received with the device.
17 Perform a tape backup and verification test with the drive as instructed in
the software documentation that came with the drive.
Optical Drive
Removing an Optical Drive
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Remove the front bezel, if attached. See "Removing the Bezel" on
3 Open the system. See "Opening the System" on page 67.
book.book Page 94 Monday, September 14, 2009 1:53 PM