Dell PowerVault DP600 - Manual (Page 44)

44
About Your System
The following DIMM
pair is not
compatible with the
memory controller:
DIMM x and DIMM y
The specified DIMM(s)
are incompatible with the
system. Ensure that only Dell-
qualified memory is used.
Dell recommends
purchasing memory
upgrade kits directly from
www.dell.com or your Dell
sales agent to ensure
compatibility.
The following DIMMs
are not compatible:
DIMM x and DIMM y
The specified DIMM(s)
are incompatible with the
system. Ensure that only ECC
FBD1 memory is used. Dell
recommends purchasing
memory upgrade kits
directly from www.dell.com
or your Dell sales agent to
ensure compatibility.
Time-of-day clock
stopped
Faulty battery or faulty
chip. See "Troubleshooting the
System Battery" on
page 154.
Time-of-day not set
- please run SETUP
program
Incorrect Time or Date
settings; faulty system
battery. Check the Time and Date
settings. See "Using the
System Setup Program" on
page 47. If the problem
persists, replace the system
battery. See "System
Battery" on page 101.
Timer chip counter 2
failed
Faulty system board. See "Getting Help" on
page 185.
Unsupported CPU
combination
Unsupported CPU
stepping detected
Microprocessor(s) is not
supported by the system. Install a supported
microprocessor or
microprocessor combination.
See "Microprocessor" on
page 117.
Utility partition
not available
The key was
pressed during POST, but
no utility partition exists
on the boot hard drive. Create a utility partition on
the boot hard drive. See the
CDs that came with your
system.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
book.book Page 44 Monday, September 14, 2009 1:53 PM