Dell PowerVault DP600 User Manual
Page 184
184
Jumpers and Connectors
5 Remove the fans from the center fan bracket. See "Removing and
6 Remove the center fan bracket. See "Removing the Center Fan Bracket" on
7 Remove the password jumper plug.
See Figure 6-1 to locate the password jumper on the system board.
8 Replace the center fan bracket (see "Replacing the Center Fan Bracket" on
page 106) and replace the fans in the bracket.
9 Reconnect the storage daughter card cables.
10 Close the system. See "Closing the System" on page 68.
11 Reconnect the system to the electrical outlet, and turn on the system.
The existing passwords are not disabled (erased) until the system boots
with the password jumper plug removed. However, before you assign a new
system and/or setup password, you must install the jumper plug.
NOTE:
If you assign a new system and/or setup password with the jumper
plug still removed, the system disables the new password(s) the next time it
boots.
12 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
13 Open the system.
14 Repeat step 4 through step 6.
15 Reinstall the password jumper plug in its original position to enable the
password protection feature.
16 Replace the center fan bracket and fans and reconnect the storage
daughter card cables.
17 Close the system, reconnect the system to the electrical outlet, and turn
on the system.
18 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Using the
System Password" on page 56.
book.book Page 184 Monday, September 14, 2009 1:53 PM