Dell PowerVault DP600 - Manual (Page 67)

Installing System Components
67
Installing the Peripheral Bay Panel (Tower Only)
1 With the bezel installed on the system, align the peripheral bay panel
with the panel opening on the bezel and insert the panel, tab-end first,
into the opening.
2 Slide the panel downward so that the tabs enter the slots in the bezel and
lock into position.
Installing the Bezel
1 Insert the hooks on the end of the bezel into the bezel slots on the right (or
bottom) side of the system front plate. See Figure 3-1 for rack systems or
Figure 3-2 for tower systems.
2 Rotate the other end of the bezel toward the front panel and press the
bezel onto the panel to engage the latch.
3 Lock the bezel.
Opening the System
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
CAUTION:
Whenever you need to lift the system, get others to assist you. To avoid
injury, do not attempt to lift the system by yourself.
1 Unless you are installing a hot-plug component such as a cooling fan or
power supply, turn off the system and attached peripherals, and
disconnect the system from the electrical outlet and peripherals.
2 If you are working with a tower system, place the system on its side on a
flat stable surface with the feet overhanging the edge of the work surface.
3 If present, unlock and remove the Kensington cable lock on the back of the
system chassis.
4 To remove the system cover, turn the latch release lock on the cover
latch counterclockwise to the unlocked position. See Figure 3-4.
5 Lift up on the latch on top of the system. See Figure 3-4.
book.book Page 67 Monday, September 14, 2009 1:53 PM