Dell PowerVault DP600 - Manual (Page 133)

Installing System Components
133
Configuring the Boot Drive
By default, the system boots from drive 0 on the 1x8 SAS backplane. The
order of boot devices is specified in the System Setup program. See "Using
the System Setup Program" on page 47.
Control Panel Assembly (Service-Only
Procedure)
Removing the Control Panel Assembly
The following procedure applies to either a rack or tower system. Figure 3-32
illustrates a control panel assembly in the rack orientation.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Remove the front bezel, if attached. See "Removing the Bezel" on
page 64.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
3 Open the system. See "Opening the System" on page 67.
4 If you have a tower system, remove the system top panel:
1 SAS RAID controller
daughter card (DIMM
not shown)
2 SAS_1 connector
(connect to SAS_B_IN
connector) 3 SAS_0 connector
(connect to SAS_A
connector)
4 1x8 SAS backplane 5 SAS_B connector 6 SAS_A connector
7 SAS_B_IN connector 8 SAS_B_OUT
connector (connect to
SAS_B connector) 9 1x2 SAS backplane
book.book Page 133 Monday, September 14, 2009 1:53 PM