Dell PowerVault DP600 - Manual (Page 102)

102
Installing System Components
Figure 3-19. Replacing the System Battery
6 Install the new system battery with the side labeled "+" facing up. See
Figure 3-19.
7 Install the new system battery.
a Support the battery connector by pressing down firmly on the positive
side of the connector.
b Hold the battery with the "+" facing up, and slide it under the
securing tabs at the positive side of the connector.
c Press the battery straight down into the connector until it snaps into place.
8 Replace all the expansion cards you removed in step 4.
9 Close the system. See "Closing the System" on page 68.
10 Reconnect the system to the electrical outlet and turn on the system and
attached peripherals.
11 Enter the System Setup program to confirm that the battery operates
properly.
12 From the main screen, select System Time to enter the correct time and date.
13 Re-enter any system configuration information that is no longer displayed
on the System Setup screens, and then exit the System Setup program.
14 To test the newly installed battery, see "Troubleshooting the System
Battery" on page 154.
1 positive side of
connector
2 system battery 3 negative side of
connector
2
3
1
book.book Page 102 Monday, September 14, 2009 1:53 PM