ADS Environmental Services FlowShark Pulse QR 775004 A1 - Manual (Page 155)

Parameter Settings 8-65
The user can replace the memory card at any time, unless the display
indicates MemoryCard active, which occurs for approximately 1
second each full hour.
Format the card using the following menu. Perform this procedure when using the
card for the first time and following each data transfer operation. The formatting
process takes 10 to 60 seconds, depending on the card capacity, and is complete when
the main screen re-appears.
Do not press any keys or turn the unit off during formatting. This
could cause irreversible damage to the card.
Figure 8-109 Card formatting request
All data saved to the card will be removed during the formatting
process.
Save FlowShark Pulse parameter settings for backup purposes or to transfer the
settings to similar measurement locations.
Select Save parameters to write the parameters to the memory card. This procedure
takes approximately 30 seconds; a progress bar displays for tracking purposes.
Figure 8-110 Saving parameters to the memory card
The Load parameters menu option displays all the configuration files available on
the card. Selecting this option transmits the file to the FlowShark Pulse.
The name of the required file is PARAMET.NIV.
save writes the parameters from the FlowShark Pulse to the memory card
load writes the parameters from the memory card to the FlowShark Pulse
The FlowShark Pulse enables the user to back up data stored in the unit within the
past 14 days for protection against data loss due to a faulty data readout, defective