ADS Environmental Services FlowShark Pulse QR 775004 A1 - Manual (Page 107)

Parameter Settings 8-17
For pipe profiles divided into two zones, set the following parameters:
Bottom zone:
• Pipe (round)
• Egg
• Rectangle
• U-Profile
• Trapezoid
• 2r Egg
• Q=f(h)
• Ellipse
Top zone:
• Custom profile
For pipe profiles divided into three zones, set the following parameters:
Bottom zone:
• Pipe (round)
• Egg
• Rectangle
• U-Profile
• Trapezoid
• 2r Egg
• Q=f(h)
• Ellipse
Center zone:
• Custom profile
Top zone:
• Pipe
Configuring individual pipe sections requires comprehensive
knowledge and experience in operating the FlowShark Pulse. To
ensure proper configuration, contact ADS for assistance in setting
up these parameters.
Sludge Level
This parameter represents the depth of the sludge that has accumulated at the bottom
of a pipe. This factor must be subtracted from the total wetted hydraulic area before
the FlowShark Pulse performs flow calculations.