Metrohm 761 Compact IC - Manual (Page 168)

4 Operation
761 Compact IC
158
Started Indication whether the sample has been started
or not:
0 sample not started
1
sample started
2 … n number of injections done
Level Calibration level (see section 4.4.5) for the
sample: Level 0 stays for normal analysis, levels
1 and greater for calibration runs. Correct filling
of this column enables to calculate calibration
coefficients automatically.
Volume Injected volume of sample in µ L.
Amount Sample amount. If this value is different for the
calibration run (c) and the sample run (s), the
component concentrations of the sample are
calculated as follows:
C
s
= C
c
• Amount
s
/ Amount
c
Shut down system after the queue finishes
If this option is enabled, the system hardware is
shut down after the sample queue has been fin-
ished (all pumps are switched off), but it re-
mains connected.
Start execution of the sample queue from the
first line with Started = 0 .
Stop execution of the sample queue after the
current determination has been finished.
Open the sample queue editor program for ed-
iting the sample queue table (see section
4.6.3).
Close the sample queue overview table.
Start sample queue
SAMPLE QUEUE OVERVIEW / Control / Start
Start execution of the sample queue from the first row with Started = 0 .
For each row, the sample-specific data are transferred to the method of
the current determination and the parameter Started is set to 1 for this
row.
If processing the sample queue is interrupted with then it can
be continued again with (with a running chromatogram only
when data acquisition is finished).