Metrohm tiBase 1.0 Manual - Manual (Page 34)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
26 ￭￭￭￭￭￭￭￭ tiBase 1.0
Variable
name
(PC-Control)
Variable
name
( tiBase 1.0 )
Description Command
.MIT .ITE Initial temperature (temperature
before start conditions are pro-
cessed) in °C DET, MET, SET, KFT, STAT,
MEAS (without T/Flow),
CAL MEAS, STDADD, DOS
.XAM .MA.MEA Maximum measured value in the
unit of the measured value DET, MET, SET, KFT, STAT,
MEAS
.XAT .MA.TEM Temperature for the maximum
measured value in °C DET, MET, SET, KFT, STAT,
MEAS
.XAD .MA.TIM Time for the maximum measured
value in s DET, MET, SET, KFT, STAT,
MEAS
.XAP .MA.[VOL] Volume with maximum measured
value in mL DET, MET, SET, KFT, STAT
.MI.GFL Minimum gas flow rate in
mL/min MEAS T/Flow
.XIM .MI.MEA Minimum measured value in the
unit of the measured value DET, MET, SET, KFT, STAT,
MEAS
.XIT .MI.TEM Temperature for minimum meas-
ured value in °C DET, MET, SET, KFT, STAT,
MEAS
.XID .MI.TIM Time for the minimum measured
value in s DET, MET, SET, KFT, STAT,
MEAS
.XIP .MI.[VOL] Volume for minimum measured
value in mL DET, MET, SET, KFT, STAT
.RMC .MR.MRC Correlation coefficient for mean
dosing rate for the whole range STAT, DOS
.RMS .MR.MRS Standard deviation for mean dos-
ing rate for the whole range in
mL/min STAT, DOS
.RM .MR.MRT Mean dosing rate for the whole
range in mL/min STAT, DOS
.MTM .MTE Temperature measurement with
sensor; 1 = on, 0 = off) DET, MET, SET, KFT, STAT,
MEAS (without T/Flow),
CAL MEAS, STDADD, DOS
.MMP .NMP Number of measuring points
(number of measuring points in
the measuring point list) DET, MET, SET, KFT, KFC,
STAT, MEAS, CAL MEAS,
DOS
.RDC# .RE{x}.DRC Correlation coefficient for mean
dosing rate in window x (1…9) STAT
.RDS# .RE{x}.DRS Standard deviation for mean dos-
ing rate in window x (1…9) in
mL/min STAT