Metrohm tiBase 1.0 Manual - Manual (Page 164)

4.4 Templates ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
156 ￭￭￭￭￭￭￭￭ tiBase 1.0
Properties
X pos.
Shows the predefined x-position for the fixed report.
Y pos.
Y position within the permitted section.
Range 0.0000 ... (max. page height) mm
Width
Shows the predefined width of the fixed report.
Height
Height of fixed report.
Range 0.0000 ... (max. page height) mm
Fixed report
Selection of a predefined fixed report.
Selection Calculations | Calibration data | Curves | Mes-
sages | List of meas. points | Result list | Raw
data (endpoints) | Standard addition | Statistics
data (brief) | Statistics data (full) | Signature list
Determination | Signature list Method | Varia-
bles | Devices used | Common variables used |
Solutions used | Sensors used
Default value Calculations
Command name
Name of the command for which a curve, a calibration curve or a measuring
point list is to be produced. With not defined, the lists for all curves present
in the determination will be produced as default.
This parameter appears only as editable field when Fixed report = Curve,
Calibration curve or Measuring point list.
Input 50 characters
Selection not defined
Default value not defined