Metrohm tiBase 1.0 Manual - Manual (Page 230)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
222 ￭￭￭￭￭￭￭￭ tiBase 1.0
4.5.2.6.3 Reprocessing rules
Dialog window: Reprocess
The following rule applies for recalculating the selected and modified deter-
minations:
With measuring commands (DET, MET, SET, KFT, BRC, MEAS, CAL MEAS)
only the evaluations with existing data will be recalculated. All other param-
eters will be ignored.
4.5.2.6.4 Modifications
4.5.2.6.4.1 Modifications - Overview
Subwindow: Database ▶ Determination overview ▶ Determinations ▶ Reproc-
ess... ▶ Reprocessing ▶ Modifications
In the subwindow Modifications of the dialog window Reprocessing
modifications can be made on the following 4 tabs:
￭ Variables
Modification of the variables used in the selected determination.
￭ Calculations
Selected determinations will be recalculated.
￭ Statistics
Modification of statistics data.
The tab Statistics will only be shown when the last determination (and
only this one) is selected from a set of determinations which, because of
the statistics defined in the method, belong together.
￭ Curve evaluation
Manual modification of the curve evaluation.
The tab Curve evaluation is only shown when a single determination
is selected that contains curves that can be evaluated.
4.5.2.6.4.2 Modifications - Variables
Tab: Database ▶ Determination overview ▶ Determinations ▶ Reproc-
ess... ▶ Reprocessing ▶ Modifications ▶ Variables
On the tab Variables the variables used in the determination can be modi-
fied.
Variable table
The variable table shows those variables used that are present in all the
selected determinations and cannot be edited directly. With a click on the
column title (columns Variable, Value) the table can be sorted according
to the selected column in increasing or decreasing order.
Variable
Shows the name of the variable. Only the those variables are displayed which
are available in all the selected determinations and can be edited. These