Metrohm tiBase 1.0 Manual - Manual (Page 259)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiBase 1.0 ￭￭￭￭￭￭￭￭ 251
4.6 Subwindow Information
4.6.1 Information - Overview
Subwindow: Database ▶ Information
General
In the subwindow Information general information about the focused
determination in the determination table is shown. The subwindow can be
switched on in the program part Database during the definition of the
layout and thus made visible. It can be enlarged and reduced as required; it
can also be maximized.
Tabs
Information about the determination is shown on the following tabs:
￭ Determination
Display of general information about determination.
￭ Method
Shows general information about the method used.
￭ Sample
Shows general information about the sample used.
￭ Configuration
Shows general information about the devices, sensors and common var-
iables used.
￭ Messages
Shows messages about the determination.
￭ Determination comment
Shows the comment on the determination.
4.6.2 Information - Determination
Tab: Database ▶ Information ▶ Determination
Display of general information about determination.
Identification
Information about the identification of the determination.
Determination ID:
Unambiguous and unmistakable identification for the determination.
Sample number:
Shows the Sample number entered in the run window.
Start counter:
Shows the start counter which is increased by +1 at the start of each deter-
mination. The start counter is saved for each client and cannot be reset.