Metrohm tiBase 1.0 Manual - Manual (Page 282)

4.8 Subwindow curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
274 ￭￭￭￭￭￭￭￭ tiBase 1.0
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved per
curve window and per client.
Selection DET | MET | SET | KFT | KFC | BRC | STAT |
MEAS | DOS
Default value DET
Note
When the dialog window is opened, those Command type will be selec-
ted as standard which applies for the curve shown in the curve window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be
edited.
Size
Selection of the quantity to be shown on the x axis.
For DET commands
Selection
Volume [mL] | Measured value | ERC | Time [s] |
Temperature [°C] | Calculated 1...3 | External
1...3
Default value Volume [mL]
For MET commands
Selection
Volume [mL] | Measured value | dMW | Time
[s] | Temperature [°C] | Calculated 1...3 | Exter-
nal 1...3
Default value Volume [mL]
For SET, STAT, DOS and KFT commands
Selection
Time [s] | Measured value | Volume [mL] | dV/dt
[µL/min] | Temperature [°C] | Calculated 1...3 |
External 1...3
Default value Time [s]