Metrohm tiBase 1.0 Manual - Manual (Page 32)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24 ￭￭￭￭￭￭￭￭ tiBase 1.0
Variable
name
(PC-Control)
Variable
name
( tiBase 1.0 )
Description Command
.BM# .BP{x}.MEA Measured value for the break
point x (1…9) in the unit of the
measured value DET, MET, MEAS (without
T/Flow)
.BT# .BP{x}.TEM Temperature for the break point x
(1…9) in °C DET, MET, MEAS (without
T/Flow)
.BD# .BP{x}.TIM Time for the break point x (1…9)
in s DET, MET, MEAS (without
T/Flow)
.BP# .BP{x}.VOL Volume for the break point x (1…
9) in mL DE, MET
.CONC .CONC Concentration of the solution
used for the command (number) DET, MET, SET, KFT, STAT,
STDADD, ADD, DOS, LQH
.MCD .DBL Duration command (total dura-
tion for the processing of the
command) in s DET, MET, SET, KFT, KFC,
STAT, MEAS, CAL MEAS,
STDADD, DOS
.MDC .DRI Current and/or last drift for drift
correction in mL/min SET, KFT, KFC
.MSD .DSC Duration start conditions (time for
processing all start conditions) in
s DET, MET, SET, KFT, STAT
.DDC .DTI Time for drift correction (time
from the start of the titration to
the end of the command) in s SET, KFT, KFC
.MCM .EME End measured value (measured
value after processing of the com-
mand) in the unit of the measured
value DET, MET, SET, KFT, KFC,
STAT, MEAS, CAL MEAS,
STDADD, DOS
.MEN .ENP Electrode zero point for the sen-
sor used for the command
(dimensionless for pH sensor or in
mV for the ISE sensor, number)
and/or electrode zero point calcu-
lated from the calibration (for
STDADD and CAL LOOP) DET pH, DET U, MET pH,
MET U, SET pH, SET U,
STAT, MEAS pH, MEAS U,
MEAS T, MEAS Conc, CAL
LOOP, DOS, STDADD
.EP{x}.DME Measured value differential for
the endpoint x (1…9) MET
.EF# .EP{x}.ERC ERC for the endpoint x (1…9) DET
.EM# .EP{x}.MEA Measured value for the endpoint
x (1…9) in the unit of the meas-
ured value DET, MET, SET, KFT, KFC