Rockwell Automation 1746-HSRV SLC Servo Control Module User Manual - Manual (Page 83)

Publication 1746-6.1.2 - July 2000
7-4 Setting Up Your SLC Servo Module
Configuring Your Processor Using AI-500 Software
Configuring your processor involves assigning the SLC Servo Module
to an open slot in the chassis, setting the file length, and entering the
parameters.
To assign the SLC Servo Module to an open slot:
1. Press F1 (Select Program/SLC-500 Addr).
2. Select project file.
3. Press Enter.
4. Press F2 (Offline Programming/Doc) The Offline Ladder Editor
screen opens.
5. Press F6 (Utility).
6. Press F3 (Type/sr).
7. Select an open slot in the chassis.
8. Press F5 (Select).
9. Select 1746-HSRV Single Axis Motion Controller from the
list.
10. Press Enter.
To set the file length and enter parameters:
1. Press F8 (SPIOCFG).
2. Press F1 and set the M0 file length to 1664 words.
3. Press Enter.
4. Press F2 and set the M1 file length to 1659 words.
5. Press Enter.
6. Press F6 and set the G file size to 0 words.
RSLogix 500 Configuring Your Processor Using RSLogix 500
Software
If you are using: Go to: