Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 167)

Rockwell Automation Publication 1715-UM001C-EN-P - March 2014 167
Configure the Redundant I/O System Chapter 5
The Internet Protocol tab appears.
Table 27 - Internet Protocol Parameters
Parameters Description
Internet Protocol (IP) Settings Displays the module’s IP settings Configuration mode.
Click the appropriate button to configure the IP settings:
• Manually configure the IP settings
• Obtain IP settings automatically by using BOOTP
• Obtain IP settings automatically by using DHCP
Internet Protocol (IP) Settings controls appear dimmed when:
• Offline
• online and a module mismatch or communication error occurs
• BOOTP or DHCP is not supported
IP Settings Configuration
Physical Module IP Address Displays the module’s physical IP address or, if you chose to configure the IP settings manually, enter a valid
physical module IP address.
Subnet Mask Displays the module’s subnet mask or, if you chose to configure the IP settings manually, enter a valid subnet
mask.
Gateway Address Displays the module’s gateway IP address or, if you chose to configure the IP settings manually, enter a valid
gateway address.
Domain Name Displays the module’s domain name or to configure the IP settings manually, enter a valid domain name.
Host Name Displays the module’s host name or enter a valid host name.
Primary DNS Server Address Displays the module’s primary DNS server IP address or if you chose to configure the IP settings manually, enter
a valid primary DNS server address.
Secondary DNS Server Address Displays the module’s secondary DNS server IP address or if you chose to configure the IP settings manually,
enter a valid secondary DNS server address.
Refresh communication This link appears when communication with the module has failed. Click Refresh communication to attempt to
restart communication with the module.
Set Click this button to commit your modifications to the module.