Rockwell Automation 1715-OF8I Redundant I/O System User Manual User Manual
Page 153
Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
153
Configure the Redundant I/O System
Chapter 5
4. Follow the prompts in the Rockwell Automation EDS Wizard.
In the rare case that you need to update an EDS file, you have to go to
et Support Now
to obtain the correct files. Also note that when you download
the EDS files, you see the Chassis EDS files that you do not see if you upload
from the module. These files are necessary for chassis selection choices only in the
Logix Designer application. Keep in mind that these are virtual chassis product
numbers and not literal catalog numbers. See the example in
.
Figure 58 - Virtual Chassis File Product Numbers
Create the Project in the
RSLogix 5000 or Logix
Designer Application
Once the Add-on Profile is installed, you are ready to create the RSLogix 5000
or Logix Designer project. In this section, you do the following:
• Create a new project.
• Configure the 1756 controller in the project.
• Add the 1756-EN2TR module to the project.