Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 123)

Rockwell Automation Publication 1715-UM001C-EN-P - March 2014 123
Chapter
3
Digital I/O Operation
1715 Digital Module
Overview
The 1715 digital I/O modules are I/O modules that provide On/Off
detection and actuation. By using the producer/consumer network model,
digital I/O modules can produce information when needed while providing
additional system functions.
The 1715 digital I/O modules mount in a 1715 Redundant I/O System and
use an I/O termination assembly mounted in an I/O base unit to
communicate via redundant 1715 adapter modules.
Before you install and use your module, you must do the following:
• Install and ground a user-supplied, 24V DC power supply.
• Determine if you are using your digital I/O module in Simplex or Duplex
mode.
• Install the correct termination assembly based on your determination for
either simplex or duplex operation.
• Configure the project in RSLogix 5000 software or the Logix Designer
application to accept the number and type of modules for the project.
Topic Page
1715 Digital Module Overview 123
Determining Input Module Compatibility 126
Determining Output Module Compatibility 127
Using Features Common to 1715 Standard Digital I/O
Modules
127
Features Specific to 1715-IB16D Digital Input Modules 129
Features Specific to 1715-OBD8E Digital Output Modules 133
Fault and Status Reporting between Input Modules and
Controllers
138
Fault and Status Reporting between Output Modules and
Controllers
139