Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 112)

112 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 2 Installation Instructions
2. Verify BOOTP network settings. Choose Tools>Network Settings.
These settings are transmitted to the module along with your IP address,
so verify that they are the correct settings.
IMPORTANT • The adapter must be physically connected to the network running the
BOOTP server.
• Multiple MAC address requests are received. The lowest MAC addresses
correspond to the leftmost adapter slot, or primary adapter module. Do not
assign an IP address to the higher MAC address requests, as these addresses
correspond to the rightmost adapter slot, or secondary module.
• It is suggested that you manually enter the MAC address. Sometimes your
personal computer’s settings can prevent you from obtaining MAC address
requests from your BOOTP/DHCP server. Please check the documentation
for your BOOTP/DHCP server for additional help.
• The MAC address is found on the label on the front of the adapter
backplane. The top MAC address corresponds to the primary adapter
module in the leftmost slot.
32060-M
00:A0:EC:00:24:8C 00:A0:EC:00:24:91
Top MAC Address