Rockwell Automation 198x Modular DeviceNet Starter Auxiliary I/O - Manual (Page 112)

5-46 Specifications
Publication 198-UM001B-EN-P September 2001
Table 5.AB 198-IB2XOB1 Specifications
Terminal Block (5.08 mm Pitch 4-Position)
Connection Capacity
Solid wire 0.13…1.5 mm 2 (24…16 AWG)
Flexible wires 0.13…2.5 mm
2
(24…14 AWG)
Flexible wires with ferrules
0.5…2.5 mm
2
(20…14 AWG)
Plastic collar 1.5 mm 2 (16 AWG)
Wire Type Use 75 C copper wire min.
Tightening Torque Spring clamp
Terminal Block (5.08 mm Pitch 2-Position)
Connection Capacity — Flexible wire 0.13…1.5 mm 2 (24…16 AWG)
Wire Type Use 75 C copper wire min.
Tightening Torque Insulation displacement
Electrical
Module Operating Voltage Range 11…25V DC
Module Voltage Rating 24V DC
Module Current Draw 14 mA @ 24V DC
Input Voltage Rating 24V DC
Input On-State Voltage Range 10…24V DC
Input On-State Current 3.0 mA @ 10V DC
7.2 mA @ 26V DC
Input Off-State Voltage Range 0…5V DC
Input Off-State Current <1.5 mA
Input Filter — Software
Selectable (with two I/O modules) Off to On 1, 2, 4, 8, 16 ms
On to Off 1.3, 2, 4, 8, 16 ms
Input Compatibility IEC 1+
Output Voltage Rating 24V DC
Output Load Current 2 A per output
Switching Device Solid-State — N300, DC14
Module Isolation 132V AC working voltage
1500V AC for 1 s